(1989), Radiation Detection and Measurement (2nd ed.), New York: John Wiley & Sons, pp. 665–666

Johns, David Martin, Ken, Analog Integrated Circuit Design, ISBN 8-7.

(2005), The Data Conversion Handbook, Elsevier: Newnes, ISBN 0-7506-7841-0 Holberg, Douglas R., CMOS Analog Circuit Design, ISBN 0-19-511644-5 However, some non-electronic or only partially electronic devices, such as rotary encoders, can also be considered ADCs. The size of the number grows with an increase in the input voltage or current. Typically, an ADC is an electronic device that converts an input analog voltage or current to a digital number. The reverse operation is performed by a digital-to-analog converter ( DAC). An ADC may also provide an isolated measurement. It may be more complex than an A/D converter, but it offers better resolution.4-channel stereo multiplexed analog-to-digital converter WM8775SEDS made by Wolfson Microelectronics placed on a X-Fi Fatal1ty Pro sound card.Īn analog-to-digital converter (abbreviated ADC, A/D or A to D) is an electronic integrated circuit that converts a continuous quantity to a discrete time digital number. The biggest advantage of such a circuit is its high speed.

As shown in the figure above, the CC signal is connected to the start conversion input in order to convert the cycle continuously. As the SAR determines each bit, digital data is also available serially. The CC signal in turn enables the latch, and digital data appear at the output of the latch. After Q0 is tried, the SAR makes the conversion complete (CC) signal HIGH to show that the parallel output lines contain valid data. This process goes on until all the bits are tried. If comparator output is HIGH, D/A output will be less than V in and the MSB will be set to the next position (Q7 to Q6) by the SAR.Īccording to the comparator output, the SAR will either keep or reset the Q6 bit. If comparator output is LOW, D/A output will be greater than V in and the MSB will be cleared by the SAR. The output is given to the D/A converter which produces an analog equivalent of the MSB and is compared with the analog input V in. The MSB of the SAR (Q7) is set as soon as the first transition from LOW to HIGH is introduced. The 8-bit latch at the end of conversation holds onto the resultant digital data output.Īt the start of a conversion cycle, the SAR is reset by making the start signal (S) high.

Till the digital output (8 bits) of the SAR is equivalent to the analog input V in, the SAR adjusts itself. The output of the comparator is a serial data input to the SAR. The analog output V a of the D/A converter is then compared to an analog signal V in by the comparator. The main part of the circuit is the 8-bit SAR, whose output is given to an 8-bit D/A converter. Successive Approximation Type Analog to Digital Converter

Analog to digital converter types